Free shipping to Ohio

Rotomolded LLDPE: why the box lasts

Every Tesseract box is one piece of LLDPE, linear low-density polyethylene, rotomolded in Estonia.

The material

LLDPE is a flexible, UV-stabilised polyethylene. It does not turn brittle in the cold and takes a hit by flexing instead of shattering.

The technical working range is from -40 °C to +60 °C.

How rotomolding works

LLDPE powder goes into a closed mold. The mold turns on two axes inside an oven at 280–310 °C, and the melt coats the inside of the mold evenly.

The result is a one-piece body made in a single cycle: no welds, no joints, no glued parts.

Frostproof & waterproof

LLDPE does not turn brittle in the cold, so the body does not crack in winter, and a rubber seal on the lid keeps rain, snow, dust and mud out.

Impact-resistant

The rotomolded body absorbs blows that would break a rigid plastic one.

Double wall

A double wall makes the box tougher and gives extra protection against impacts.

Why not injection molding

Injection-molded parts can have weld lines where the plastic flows meet, and a weld line may be weaker than the rest of the wall. A rotomolded body has none, so it has no built-in weak spot.

Made in Estonia

Tesseract boxes are designed and rotomolded at our own facilities in Estonia, from the first sketch to quality control.

See how a box is developed on the About Tesseract page.